Security Command
Security Command
Breadcrumbs

Auto Configure ECP and DSC Passthru

After setting up host panel and installing the communicator, complete the following steps to remotely configure the communicator.

ECP Setup

  1. Go to Location Groups.

  2. Find and select the location name.

  3. In the menu, go to Programming > Location Options.

  4. In Keypad Input, select ECP.

  5. In ECP Partition, enter the number of the partition where you want the communicator to operate.

  6. Select Begin ECP Setup.

  7. If the host panel is a VISTA 128, turn on VISTA 128.

  8. Enter the host panel’s installer code in VISTA Installer Code.

  9. Select Begin.

  10. After setup is complete, Security Command automatically retrieves zones from the host panel. If you need to retrieve zones again later, open Location Options and select Get Zones.

DSC Setup

  1. Go to Location Groups.

  2. Find and select the location name.

  3. In the menu, go to Programming > Location Options.

  4. In Keypad Input, select DSC.

  5. Select Begin DSC Setup.

  6. Enter the host panel’s installer code in Installer Code.

  7. Select Begin.

  8. After setup is complete, Security Command automatically retrieves zones from the host panel. If you need to retrieve zones again later, open Location Options and select Get Zones.